Travertine
| Discount | After Discount |
|---|---|
| for 2 products -5% | 76,16 € |
| for 3 products -15% | 68,14 € |
What is travertine?
Machine tinting of color from catalogs
of PASTELO&FORTUNA Tinting System in over 20,000 colors.
Swiss tinting pigments of the highest quality.
It is used for finishing walls, ceilings, facades, columns.
ECOLOGICAL PRODUCT
We are committed to providing you with not only quality and durable products, but also those that are environmentally friendly. Fortuna products are:
- Environmentally friendly: do not contain harmful chemicals, including volatile organic compounds (VOCs), which can have negative effects on indoor air quality and the environment.
- Sustainable: made from natural, sustainable materials that reduce negative environmental impact.
- Our commitment to the environment extends to our manufacturing processes, which prioritize resource efficiency and waste reduction. With our eco-friendly products, you can enhance the beauty of your space while minimizing your environmental footprint.
All Fortuna brand products are water-dilutable and comply with all European environmental standards.
Applying Travertine
Tools
It is applied with a trowel and shaped with a trowel.
Consumption rate
2-4 m2/l, and may vary depending on the substrate, method and conditions of application. To reduce consumption, the base must be flat and primed.
Drying Time
2-4 hours at 20°C.
Always wait until the previous layer is completely dry.
Dilution
Up to 5% water if necessary. The plaster is ready to use and does not need to be diluted.
Step 1
Preparing the Base
Prepare the base very well. If necessary, clean and sand.
For friable and porous surfaces, first apply Fortuna nano impregnator – diluted in a ratio of 1:5 primer/water. It is very important for dust removal and surface hardening.
Step 2
Priming the Base
A previously prepared solid base is primed with Fortuna wall primer , another suitable primer or white latex until an even white color is achieved.
Step 3
Applying the Effect
Apply FORTUNA Travertin with a trowel in one or two layers, depending on the desired structure. The relief of the decorative effect is determined by the movements of the tool. Leave to dry for at least 24 hours
Step 4
Shaping the Effect
Using a trowel, “hole” the applied coating in places before it dries. Smooth lightly and cycle before the coating dries. Let dry for at least 24 hours.
Step 5
Shaping the Effect
Using a sponge, brush or trowel, color the dried white coating with Velluto regolare. Depending on the desired effect and craftsmanship, it is possible to achieve a variety of color and relief combinations.
